Page 1 of 1
Label and layout
Posted: Fri Nov 03, 2017 9:44 am
by froggy
Hello
In order to create covers for 3'' floppy disks, I am looking for any information, like the dimensions of a regular cover (Amsoft style) or, even better, any templates you may have been using (Photoshop, Illustrator, etc).
cheers,
Froggy
Re: Label and layout
Posted: Fri Nov 03, 2017 10:01 am
by Chema
My 3" label for Blake's 7 was made by hand on Publisher, and is 70x70mm and with a spine of 5mm
For 3.5 disks there are templates available (Avery templates are quite famous) and they can be installed on Publisher directly through the template configuration options.
Re: Label and layout
Posted: Fri Nov 03, 2017 1:11 pm
by froggy
that's the label for the floppy itself. I am looking for the one for the case, the one printed with the graphic cove that you fold (not glue) into the case.
Re: Label and layout
Posted: Fri Nov 03, 2017 2:52 pm
by Chema
Ah, ok. Sorry I misunderstood.
Just measured one: height is something such as 104 mm, and width 84mm, with a spine of aprox 6mm in width, and the short side that comes after the spine is around 16mm, leaving aprox 67mm for the back side.
Not sure if I made myself understandable
Re: Label and layout
Posted: Fri Nov 03, 2017 7:01 pm
by Dbug
Hope that helps:
- 3" Amsoft CF-2 floppy sleeve
Re: Label and layout
Posted: Fri Nov 03, 2017 8:25 pm
by froggy
Thanks to you Chema & Dbug